Adjusting The Feed - Metabo BE 1100 Operating Manual

Operating Guide

4.3.3. Adjusting the Feed

- If the feed extent runs out and feed wheel ① can
not be turned anymore, the adjusting socket ②
must be released and locked to a lower groove.
- If the pressure is >12 bar, use the chain block
for this operation! The use of the chain block is
explained in chapter 4.6.
- At first, switch of the driving unit.
- Screw the feed wheel ① counter clockwise.
- Don't unscrew it too much as the hook of the pilot
drill might break.
- Grip the adjusting handles ③ and push them
firmly forward.Turn the adjusting socket ② until it
can be released.
- Push the adjusting socket down in the direction of
the next groove.
- Continue to turn the feed wheel ① counter
clockwise until the next groove can be reached.
- Lock the adjusting socket ② to the next groove
by turning it clockwise.
Warning: If you are unsure about the forces
acting on the shaft while releasing it, use the chain
block for this operation. From the manufacturers
experience, it is advisable to use it at a pressure
>12 bar. See chapter 4.6 how to use the chain
block.
© Danfoss | 2017.06
JIP Hot Tapping Machine
②
①
③
B
B
VI.KD.G1.02 | 17