Assembly Of The Shaft For Hole Saws < 32 Mm; Assembly Of The Danfoss Jip Adapter Socket - Metabo BE 1100 Operating Manual

Operating Guide
4.2.2 Assembly of the shaft for hole saws < 32 mm
- For hole saws <32mm and >24mm use
the small chuck ⑧. The smallest chuck ⑨
should be used for hole saws <20mm.
- Screw the hole saw ③ to the chuck ⑧ or
⑨ depending on the hole saw size.
- The magnet ② has to be put around the
pilot drill ① and pushed into the hole of the
chuck ⑧ or ⑨.
- The groove in the pilot drill ① has to be
alligned to the screw G.
- Attach the assembly to the shaft ⑤. Use
shaft extensions ⑦ or the feed extension
socket ⑥ if necessary.

4.2.3 Assembly of the Danfoss JIP Adapter Socket

The Danfoss JIP Hot Tapping Adapters are delivered in a tool box including all the sizes from DN 20 to DN
100. For the sizes DN 25 as well as for DN40 reduction sockets have to be added to adapter of the next size
as shown in the following picture.
12 | VI.KD.G1.02
JIP Hot Tapping Machine
⑥
⑤
⑦
⑧
③
G
②
①
CAUTION: If the pilot drill it too long
it might be impossible to
close the valve !
⑨
© Danfoss | 2017.06