Mounting Considerations - Garmin AQUAMAP 10x2 Series Installation Instructions Manual

Dimensions and Ports (AQUAMAP 10x2 Series)
316.8 mm
1 3
2
Item
8-pin XDCR
1
LAN
2
Power
3
Ground
4
Video CVBS input - BNC
5
GPS antenna - BNC
6
HDMI video output
7
NMEA 0183
8
NMEA 2000
9
Dimensions and Ports (AQUAMAP 12x2 Series)
358.8 mm
1 3
2
Item
8-pin XDCR
1
LAN
2
Power
3
Ground
4
Video CVBS input - BNC
5
GPS antenna - BNC
6
HDMI video output
7
NMEA 0183
8
NMEA 2000
9
AQUAMAP™ 10x2/12x2 SERIES
4
5 8
7
6 9
Usage
4
5 8
7
6 9
Description
Typical System Integration
Monitor
NMEA 2000
Network
68.5 mm
Tools Needed
• Drill
◦ Bail mount: drill bits appropriate for the surface and hardware
◦ Flush mount: 14 mm (
nut plate), or 3.2 mm (
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
• Marine sealant (recommended)

Mounting Considerations

This device should be mounted in a location that is not exposed to extreme
temperatures or conditions. The temperature range for this device is listed in
the product specifications. Extended exposure to temperatures exceeding the
specified temperature range, in storage or operating conditions, may cause
device failure. Extreme-temperature-induced damage and related conse-
quences are not covered by the warranty.
When selecting a mounting location, you should observe these consider-
ations.
• The location should provide optimal viewing as you operate your boat.
68.5 mm
• The location should allow for easy access to all device interfaces, such as
the keypad, touchscreen, and card reader, if applicable.
• The location must be strong enough to support the weight of the device
and protect it from excessive vibration or shock.
• To avoid interference with a magnetic compass, the device should not be
installed closer to a compass than the compass-safe distance value listed
in the product specifications.
• The location must allow room for the routing and connection of all cables.
• The location must not be a flat, horizontal surface. The location should be
in a vertical angle.
The location and viewing angle should be tested before you install the
device. High viewing angles from above and below the display may result
in a poor image.
Camera
AQUAMAP
LAN
Antenna Radar
/ in.), 6 mm ( / in.) and 3.6 mm (
9 1
16 4
/ in.) drill bit (with no nut plate)
1
8
NOTICE
Transducer
2nd AQUAMAP
Panoptix
/ in.) (with
9
64
3