HP IntelliJack NJ1000G Quick Start Manual page 12

If the end of the cable is terminated with a male connector, connect the network

cable directly into the Ethernet uplink port.
7. Mount the NJ1000G to the Wall
After you connect the NJ1000G to the network, follow these steps, as shown in
the next figure:
1 Mount the NJ1000G to the wall-mount bracket.
CAUTION: Make sure that the vents along the edges of the NJ1000G faceplate
are clear of any obstructions to allow airflow to vents.
2 Slide the NJ1000G onto the wall-mount bracket, ensuring that the
four hooks on the bracket fit into the four slots on the back of the
NJ1000G.
12