HP IntelliJack NJ1000G Quick Start Manual page 11

Gigabit switch
Table of Contents

Advertisement

5. Set Up the Network Cabling
The network cabling (from the wiring closet to the wall opening) may already be
installed. If it is not, install the cabling following these general guidelines.
CAUTION: HP recommends that a professional cable installer perform these
procedures. Be sure to adhere to local safety and regulatory codes during the cable
installation.
1
Connect one end of an Ethernet cable to the network. Usually, this
connection is made in a network wiring closet, via the patch panel.
2
Terminate the other end of the cable at the location where the
NJ1000G is being installed (using either a female or male RJ-45
connector). Refer to the connector manufacturer's instructions for
terminating the cable. Be sure to test the connector and verify that it
is working.
6. Connect the NJ1000G to the Network
The method for connecting the NJ1000G to the network is determined by how
the network cable is terminated, as described in step 5.
If the end of the cable is terminated with a female RJ-45 connector, use one of
the RJ-45 coupler cables included in the NJ1000G package to connect the
NJ1000G to the network cable.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents