Specifications; Unpacking; Applications - Ryobi SA1202 Operator's Manual

DRILL-DRIVER SA1202
Chuck 3/8 in. (10 mm) Keylessw
Motor DC Motor 12 Volt
Gear Train Two Speed
Switch Variable Speed
No Load Speed 0-300 RPM (Low)
0-1000 RPM (High)
Clutch 24 Positions
Charger Input 120 V, 60 Hz, AC only
Charge Rate 1 Hour
Torque Maximum 220 in.lbs.
INSTRUCTIONS
When unpacking the tool:
Carefully remove the tool and accessories from the box.
Make sure that all items listed in the packing list are in-
cluded.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
Cordless Drill
Charger
Battery Pack (2)
Operator's Manual
Case
You may use the two speed drill for the purposes listed below:
Drilling in wood
Drilling in ceramics, plastics, fiberglass, and laminates
Drilling in both hard and soft metals
Using driving accessories, such as driving screws with screwdriver bits
Mixing paints

SPECIFICATIONS

SA14402
3/8 in. (10 mm) Keyless
DC Motor 14.4 Volt
Two Speed
Variable Speed
0-400 RPM (Low)
0-1400 RPM (High)
24 Positions
120 V, 60 Hz, AC only
1 Hour
Maximum 270 in.lbs.

UNPACKING

If any parts are missing do not operate the tool until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.

APPLICATIONS

Page 7
SA1802
1/2 in. (13 mm) Keyless
DC Motor 18 Volt
Two Speed
Variable Speed
0-350 RPM (Low)
0-1300 RPM (High)
24 Positions
120 V, 60 Hz, AC only
1 Hour
Maximum 400 in.lbs.
WARNING: