Stamina X Water Rower 35-1442 Owner's Manual page 14

OPERATIONAL INSTRUCTIONS
HOW TO FILL AND EMPTY THE TANK
1. Remove the FILL PLUG(21) from the UPPER TANK(18).
2. To fill with water, refer to illustration C. Place the FUNNEL(95) into the tank. Use a water cup, or
the SYPHON PUMP(94) and a bucket to fill the tank. Use Water Level Gauge on the side of tank to
measure volume of water in tank to the desired level.
3. To empty tank, refer to illustration D. Place a bucket next to the rower. Use the SYPHON PUMP(94) to
pump out the water from the tank into the bucket.
4. Once completed, insert the FILL PLUG(21) into the UPPER TANK(18). Please wipe excess water
from the frames after filling.
NOTE: 1. Fill the tank with municipal water, do not use well water. If municipal water is unavailable, use
distilled water. Refer to the Maintenance section for recommendations on water treatment.
2. The water in the tank is not for human or animal consumption. Please dispose of the water
properly after removal from the tank.
WATER LEVEL
Refer to the detail view of illustration C. The Water Level Gauge is positioned on the side of the tank.
The maximum level to fill the tank is Level 7. DO NOT fill above the Maximum Level - this could void the
warranty. The standard calibration level is Level 6.
The amount of resistance is dictated by the amount of water in the tank. For example Level 2 of water
offer light resistance, Level 6 offers the heaviest resistance.
Water Cup
C.
Water Level Gauge
14
D.