Specifications; Important Information For Recharging Hot Batteries; Disposal Of The Exhausted Battery; Battery Pack Preparation For Recycling - Ryobi CTH1202K2 Operator's Manual

DRILL-DRIVER
Chuck
Motor
Gear Train
Switch
No Load Speed
Clutch
CHARGER
Input
Charging Voltage 12.0 V
Charge Rate

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

When using your drill-driver continuously, the batteries in
your battery pack become hot. You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
To preserve natural resources, please
Y
recycle or dispose of batteries properly.
R B R C
This product contains nickel-cadmium
battery. Local, state, or federal laws may
N i C d
prohibit disposal of Nickel-Cadmium
batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
For more information on battery recycling call 1-800-8
BATTERY.
WARNING:
Do not attempt to disassemble the battery pack. Fire or injury may result.
WARNING:
The operation of any power tool can result in foreign objects being thrown into your
eyes, which can result in severe eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side shields and a full face shield
when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shields.

SPECIFICATIONS:

CTH1202K2
3/8 in. Keyless
DC Motor 12.0 V
Two-Speed
Variable Speed
0-300 RPM (Low)
0-1000 RPM (High)
24 Positions
1400666
120 V, 60 Hz, AC only 120 V, 60 Hz, AC only 120 V, 60 Hz, AC only
1 Hour

DISPOSAL OF THE EXHAUSTED BATTERY

CTH1442K2
3/8 in. Keyless
DC Motor 14.4 V
Two-Speed
Variable Speed
0-350 RPM (Low)
0-1300 RPM (High)
24 Positions
1400656
14.4 V
1 Hour
occur under normal circumstances. Refer to "Charging
Your Drill-Driver" for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger to
your nearest RYOBI AUTHORIZED SERVICE CENTER for
electrical check.
BATTERY PACK PREPARATION FOR
RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with
heavy duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its
components. Also, never touch both terminals with metal
objects and/or body parts, as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
Page 6
CTH1802
1/2 in. Keyless
DC Motor 18.0 V
Two-Speed
Variable Speed
0-350 RPM (Low)
0-1300 RPM (High)
24 Positions
1400667
18.0 V
1 Hour