Table of Contents
Advertisement
Press and Hold
Select button
TUNER
SETUP
Menu
1. Enter the Setup Menu by pressing and holding
the SELECT button.
2. TUNER SETUP appears. Press MEM Up/Down
until UPDATE FIRMW appears on the tuner.
3. Press MODE/BAND to enter the UPDATE FIRMW
menu.
4. "Hold BAND" appears on the tuner.
5. While pressing and holding MODE/BAND,
"After update cycle power" appears on the tuner
display.
6. When "Start Update" appears on the tuner dis-
play, start the update program. "Finished"
appears on the computer screen when complete.
7. Cycle power to the tuner.
Factory Initialization (Chassis)
The Factory Initialization procedure allows the
erasure of all programmed settings and returns
ST2 Chassis Setup Procedures
SOURCE
UPDATE
NUM
FIRMW
Procedure
Procedure
Mode
Mode
Band
Band
HOLD
TUNER
MODE
#
After update
Mode
cycle Power
Band
SOURCE
NUM
Start
Update
Mode
Band
Cycle Power
them to the factory default settings.
1. Enter the Setup Menu by pressing and holding
the SELECT button.
2. TUNER SETUP appears. Press MEM Up/Down
until FACTORY INIT appears on the tuner.
3. Press MODE/BAND to enter the FACTORY INIT
menu.
4. "Are you sure" appears on the tuner. Using the
Tune Up/Down buttons, view the "Yes" and "No"
selections.
5. Press MODE/BAND to select. A "No" selection
returns to the top of the Factory Init menu. A
"Yes" begins the initialization.
6. "Please wait" appears on the tuner during the
process and "Cycle Power" appears when com-
plete.
7. Cycle power on the ST2S tuner.
ST2S TUNER PROGRAMMING
ST2 TUNER SETUP MENU
FACTORY
SYSTEM
INIT
INFO
Procedure
Procedure
Mode
Band
This
Procedure
Mode
returns the
Band
ST2 Tuner
to its
Factory
settings
Mode
Mode
Band
Band
Are you sure
Mode
Band
YES
NO
Mode
Band
Please wait
Cycle Power
Chassis
Setup
Menu
29
Advertisement
Table of Contents
