Uno-Lrc1 Remote Control With Cav6.6 - Russound ST2S Installation Manual

Smart tuner
Hide thumbs Also See for ST2S:
Table of Contents

Advertisement

ST2S OPERATION

UNO-LRC1 REMOTE CONTROL WITH CAV6.6

UNO-LRC1 Remote Control Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-LRC1 will bring
the tuner out of standby mode when used with the
UNO keypad.
Selecting the desired tuner
To select a tuner, push
number preassigned to Tuner 1 (SIRIUS) or Tuner 2
(AM/FM), or use the UNO numeric source inputs at
the bottom of the UNO-LRC1.
Selecting the desired band (AM/FM only)
Push
to toggle between AM/FM reception.
Selecting a Mode (SIRIUS)
Push
,
IUS operating modes.
Exiting a Mode (SIRIUS)
Press
or
to exit SIRIUS operating mode
menu.
Signal Strength mode (SIRIUS)
Press and hold
the signal strength rating. To exit press
Selecting the desired frequency or channel
Use the Channel
for manual tuning. To move quickly through the
channels, press and hold the button for more than
1.5 seconds. To directly select a station or channel,
enter the three- or four-digit channel or frequency
26
and choose the source
or
to toggle between SIR-
and release. The display shows
.
and
or
and
Frequency Seek (AM/FM only)
The SEEK function is performed by pressing and
releasing the Select
higher frequency station press
lower frequencies. Tuning begins at the current fre-
quency, seeks upward (or downward) and stops at the
next tuned station. Pushing
tinues the SEEK function. Once the highest frequency
is reached, the tuner continues SEEK mode at the
lowest frequency.
Frequency Scan (AM/FM only)
To scan, press and hold then release
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press
again.
Selecting a Bank
To select a bank, press and hold
or
for bank down.
Recalling a Memory Preset
Press
and
or
through a loop of all the memory presets for the cur-
rently selected bank. Only configured presets will be
displayed.
Mute
Press the
button to mute/unmute the tuner
audio output.
or
or
. To seek
. Press
for
or
again con-
. The
for bank up
and
to scroll

Advertisement

Table of Contents
loading

This manual is also suitable for:

St2

Table of Contents