Uno-S2 Keypad Controls With Cav6.6 - Russound ST2S Installation Manual

Smart tuner
Hide thumbs Also See for ST2S:
Table of Contents

Advertisement

ST2S OPERATION

UNO-S2 KEYPAD CONTROLS WITH CAV6.6

CAV6.6-UNO-S2 Keypad Operation
NOTE: To control the ST2 Tuner through the
UNO-S2 keypad, the tuner must be configured
as a source using the CAV6.6 programming
steps.
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-S2 keypad will
bring the tuner out of standby mode.
Selecting the desired tuner
On the UNO-S2 keypad, press
either Tuner 1 (SIRIUS) or Tuner 2 (AM/FM) by
choosing the tuner's preassigned source num-
ber.
Selecting the desired band (AM/FM only)
Push
to toggle between AM band and FM
band reception.
Selecting a Mode (SIRIUS)
Push
to toggle between SIRIUS modes.
Exiting a Mode (SIRIUS)
Press and release
exit SIRIUS mode selection menu.
Selecting the desired frequency or channel
Use
and
for manual tuning or channel
selection. The frequency or channel will appear
on the keypad and the active tuner. To move
quickly through the channels, press and hold
either
or
for more than 1.5 seconds
24
to select
until EXIT is displayed to
.
Frequency Seek (AM/FM only)
A press on
will seek the next higher tune-
able station. If a tuneable station is not found,
end the SEEK function by pressing
Frequency Scan (AM/FM only)
To scan, press and hold then release
tuner scans through tuned stations with a 5-sec-
ond preview before moving to the next station.
To end scanning, press
Signal Strength Mode (SIRIUS)
To check SIRIUS signal strength, press and hold
then release. The display shows the signal
strength rating. To exit, press
Selecting a Bank
To select a bank, press and hold
up or
for bank down. The bank's name will
be temporarily displayed on the UNO-S2.
Recalling a Memory Preset
Press
and
to scroll through the memo-
ry presets for the selected bank. This procedure
will step through all of the presets in the current
bank, then loop back to start at the first one.
Only configured presets will be displayed.
Mute
Press
to mute/unmute the tuner audio output.
again.
. The
again.
again.
for bank

Advertisement

Table of Contents
loading

This manual is also suitable for:

St2

Table of Contents