Midland CT2000 Instruction Manual page 19

Scan mode
Display Mode
Repeater Tone
Password lock
Back Light
Step
Sub screen
Key fun PW
Key fun Mz
Key fun CT
Key fun V/M
Key fun A/B
Instr Screen
TX Channel
TX inh
Reset
Sub ring
* the option list may vary in case some DTMF settings have been modified with the op-
tional programming kit.
Midland CT2000 instruction guide
13 Scan mode
14 Selection amongst: frequency
mode, channel mode and
memory mode
15 Selection of the repeater access
tone
16 Lock with password
17 Backlight on interval
18 Frequency step selection
19 Selection of the function in the
upper part of the screen
20 Selection of the function of the
PW control
21 Selection of the function of the
Mz control
22 Selection of the function of the
CT control
23 Selection of the function of the
V/M control
24 Selection of the function of the
A/B control
25 Welcome message
26 Selection of the tx mode
between selected channel/VFO
and last received channel/VFO.
27 Enabling of the tx lock
28 Reset
29 Rx beep sound in the sub-VFO OFF, ON
TO, CO, SE
Vfo Mode, CH Display
Mode, MR Display Mode
1750Hz, 2100Hz, 1000Hz,
1450Hz
OFF, ON
On, 5s, 10s
2,5 - 5 - 6,25 - 7,5 - 8,33
- 10 - 12,5 - 15 - 20 - 25 -
30 - 50 kHz
OFF, Frequency, Voltage
A/B, LOW, MONI, SCAN,
TONE,M/V,MHZ,MUTE
A/B, LOW, MONI, SCAN,
TONE,M/V,MHZ,MUTE
A/B, LOW, MONI, SCAN,
TONE,M/V,MHZ,MUTE
A/B, LOW, MONI, SCAN,
TONE,M/V,MHZ,MUTE
A/B, LOW, MONI, SCAN,
TONE,M/V,MHZ,MUTE
OFF, Char String, Picture
Last Received, Select
Tx Enable, Tx Inhibit
Factory, Setup
| 15