Midland CT2000 Instruction Manual page 11

1. Power ON/OFF control. Keep pressed to turn on/off the unit.
2. TX LED: transmission led; it lights up red while the radio is transmitting
Main knob: it allows to select many settings. Rotate it to look through the
3.
menu, change frequency, channel, scan direction, etc
4. F key: function key. By pressing this button you will activate the secon-
dary functions shown on the front keys of the radio.
5. Mz (ST): shortly press to change the frequency band of 1MHz in VFO
mode or to skip 10 channels forwards or backwards. Keep pressed to
adjust the frequency of 10MHz. Rotate the main knob to select the desi-
red option and confirm by pushing Mz again.
6. PW/ : shortly push to change the level of the output power (high:
25W/middle: 10W/low: 5W). Long press: you will enter the frequency
offset setting; push the button again to enable you to change the offset
direction; rotate the knob to set the desired level and confirm your selec-
tion by pushing PW again.
7. Multicolor graphic display.
8. CT/T-S: push this button to enable the CTCSS/DCS tones in tx and rx.
T-S: push F and then CT to select the desired tone.
9. V/M –MW. Short press: to switch from frequency to channel mode. Long
press: channel storage. MW: press F followed by V/M for a quick storage
of the first channel available.
10. A/B –SQ: shortly press to switch from the main display to the secondary
one. SQ: push F and then A/B to change the squelch level.
11. VOL: volume knob. Rotate the knob to select the desired volume level.
12. MIC: microphone connector. Plug-in the microphone into this jack.
Midland CT2000 instruction guide
: Press F and then PW to lock the keypad.
| 7