Install Projector Stand (Cinewide With Autoscope, Floor-Mount) - Runco Video Xtreme VX-40d Owner's Operating Manual

DO NOT OVER-TIGHTEN THE SCREWS.
Caution
(Skip this step if you are installing a fixed CineWide anamorphic lens, or
ceiling-mounting an AutoScope-equipped projector.)
If you are installing the VX-40d/-50d/-60d/-80d in an upright position (not
ceiling-mounted), use the supplied hardware to attach the projector stand to the bottom
of the projector as shown below. This stand allows the projector to lie flat on the mounting
surface with the AutoScope lens motor installed.
AutoScope stand used
for floor-mounted
projector
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual 27
Installation
Install Projector Stand
(CineWide with
AutoScope, Floor-Mount)