Installing the HP 98701 A
1. Remove the top cover by loosening the two screws at the lower rear
of the back panel. Lift the rear of the cover and slide to the rear
until clear of the front panel. Carefully set the top cover aside.
2. Loosen the four captive screws all the way.
3. Remove the two flathead screws near the top sides of the rear panel.
4. Swing the rear panel down to gain access to the card cage.
5. Remove the Color Map card from the bottom slot.
6. Remove the HP 98701A from its protective bag and insert it into
the card slot above the color map card (the second slot from the
bottom).
7. Reinstall the Color Map card in the bottom slot
8. Swing the rear panel up and secure it with the four captive screws.
9. Install the two flathead screws that secure the rear panel to the
side frames.
10. Install the top cover and secure it with the two round head screws
removed in step 1.
2-16
Environmental/Installation/Preventive Maintenance