US Robotics USR3510 Quick Start Manual

USR3510
Courier M2M Cellular Gateway

Quick Start Guide

To begin using the gateway, follow the simple steps in this
guide.
1. Attach included antennas to the antenna connectors on
the front of the device.
2. Make sure that a service plan is associated with the
device (for Sprint or Verizon Wireless) or with a SIM card
(AT&T or T-Mobile).
3. To install the SIM (AT&T or T-Mobile):
• Remove the four Torx T6 screws from the top cover plate
on the back of the unit and remove the plate.
• Insert the SIM into the SIM slot as shown in the picture on
the right.
• Replace the top cover plate and its four TorxT6 screws.
WARNING!
LAN to WAN is on by default. Once connected any Internet
activity on your system will use Cellular Data. For
configuration and more information go to
www.usr.com/support/3510.
4. Register your gateway to the provisioning server
• Go to the USRobotics provisioning server:
http://www.usr.com/activate/3510
• Sign in and follow the instructions.
5. Power up the gateway by plugging in the provided
power supply into the connector on the back of the
device.
6. Connect an Ethernet cable to the gateway's Ethernet
port on one end and a computer on the other end.
7. Open a web browser on the computer and enter the
address 192.168.1.1 into the address bar. Enter the
default username (admin) and password (admin). After
a successful login, the Home screen will appear.
USRobotics
1300 E. Woodfield Road, Suite 506
Schaumburg, IL 60173-5446
www.usr.com
Revision 3.0
4a