Table of Contents
Advertisement
Installing the Cisco MDS 9396T Switch
Step 2
Insert the stripped end of the grounding wire into the open end of the grounding lug, and use a crimping tool to crimp
the lug to the wire. Verify that the ground wire is securely attached to the grounding lug by attempting to pull the wire
out of the crimped lug.
Step 3
Secure the grounding lug to the chassis grounding pad with two M4 screws, and tighten each screw to 11.5 to 15 in-lb
(1.3 to 1.7 N·m) of torque.
Step 4
Prepare the other end of the grounding wire and connect it to an appropriate grounding point in your site to ensure an
adequate earth ground for the switch. If the rack is fully bonded and grounded, connect the grounding wire as explained
in the documentation provided by the vendor for the rack.
Installing and Remvoing Components
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing. Statement 1034
Caution
During this procedure, wear grounding wrist straps to avoid ESD damage to the switch.
Installing and Removing the Linecard Expansion Module
This section provides instructions for installing and removing the Linecard Expansion Module.
Installing the Linecard Expansion Module
To install a Linecard Expansion Module, follow the steps provided in this section:
Before you begin
If the LEM blank module is installed, remove it as follows:
1. Unscrew the locking screw.
2. Gently pull the linecard expansion module ejector till the linecard expansion blank module is slightly
ejected.
3. Remove the linecard expansion blank module.
Step 1
Power off the switch.
Step 2
Gently pull the LEM ejector so as to insert the LEM.
Step 3
Gently slide the LEM into the LEM bay till it clicks into place with the help of the Linecard Expansion Module ejector.
Step 4
Secure the Linecard Expansion Module ejector with the locking screw.
Cisco MDS 9396T Multilayer Fabric Switch Hardware Installation Guide
Installing and Remvoing Components
35
Advertisement
Table of Contents
