Standard Power Cords; Jumper Power Cords - Cisco MDS 9396T Hardware Installation Manual

Standard Power Cords

Standard Power Cords
Cisco standard power cords for the Cisco MDS 9396T switch have an IEC C15 connector on the outlet end
of the cord and a country specific plug on the inlet end of the cord. To see the list of supported standard power
cords, see the

Jumper Power Cords

Jumper power cords have an IEC C15 connector on the outlet end of the cord and an IEC C14 connector on
the inlet end of the cord. This cord is compatible with IEC C13 outlet receptacles. This type of outlet receptacle
is commonly used for power distribution inside cabinets.
The following figure lists the available plug types and cord descriptions.
Figure 18: Description of Jumper Power Cords for Cisco MDS 9396T Switch
Cisco MDS 9396T Multilayer Fabric Switch Hardware Installation Guide
58
Cisco MDS 9396T 32-Gbps 96-Port Fibre Channel Switch Data
Cable and Port Specifications
Sheet.