Configuring A Two-Post Center-Mount - Dell Z9100-ON Installation Manual
Open networking
Hide thumbs
Also See for Z9100-ON:
- Installation manual (45 pages) ,
- Deployment manual (78 pages) ,
- Installation manual (45 pages)
Table of Contents
Advertisement
Figure 6. Two-Post Flush-Mount Configuration
2.
Attach one rail to the front post flange with two user-supplied screws. See item 2.
3.
Slide the plunger bracket forward against the vertical post and secure the plunger bracket to the post
flange with two user-supplied screws. See item 3.
4.
Repeat this procedure for the second rail.
Configuring a Two-Post Center-Mount
To configure a two-post center-mount installation, follow these steps.
1.
Slide the plunger bracket rearward until it clicks into place and secure the bracket to the front post
flange with two user-supplied screws. See the following illustration, item 1.
18
Install the Z9100–ON
- Quick Links:
- Accessing the Rs-232 Console Port
Hide quick links:
Advertisement
Table of Contents
