Konica Minolta AccurioPress C3080 User Manual page 24

2.2 Installation Procedures
3
Install the bottom auxiliary guide assy [A] in the Large Ca-
pacity Unit LU-202m/LU-202XL/LU-202XLm tray.
% Check the curl direction at the leading edge of the en-
velope, and remove the holding paper, if necessary.
% Align the positioning pin of the bottom auxiliary guide
assy [A] with the installation hole of the tray.
% Align the detent of the bottom auxiliary guide assy [A]
with the groove on the back end guide.
4
Hold the flap of the envelope to use and droop vertically.
5
Put the leading edge on a flat surface to check the curl di-
rection and that the curl amount is 8 mm or less.
Downward curl: With MK-746 (refer to Step 8 and later)
Upward curl: Without MK-746
NOTICE
Envelopes with 8 mm or more curl amount are not guaran-
teed.
6
Align the adjusting block assies (2 pieces) to K1 and K0 on
the indicating label, and install them.
% Align the mark on the adjusting block assy with the
mark on the indicating label.
AccurioPress C3080/C3080P/C3070, AccurioPrint C3070L
Curl direction
Downward curl
Upward curl
Curl amount
K1 (270 x 382 mm)
K0 (287 x 382 mm)
2
8mm or
less
2-16