Konica Minolta AccurioPress C3080 User Manual page 20

2.2 Installation Procedures
7
Install the guide shaft to the back edge guide base of the
bottom auxiliary guide assy [A].
8
Close the upper door.
Using K2 (240 x 332 mm) Envelopes
The following parts need to be installed when K2 envelopes are used.
- Bottom auxiliary guide assy [A] (1 piece)
- Adjusting block assy (2 pieces)
- Guide shaft (1 piece)
1
Open the upper door.
2
Remove the holding paper.
% Hold the projection with your fingers and slide the hold-
ing paper in the arrowed direction, and remove it.
3
Install the bottom auxiliary guide assy [A] in the Large Ca-
pacity Unit LU-202m/LU-202XL/LU-202XLm tray.
% Align the positioning pin of the bottom auxiliary guide
assy [A] with the installation hole of the tray.
% Align the detent of the bottom auxiliary guide assy [A]
with the groove on the back end guide.
AccurioPress C3080/C3080P/C3070, AccurioPrint C3070L
2
2-12