Seatalk Connections - Raymarine ST4000+ Owner's Handbook Manual

81131_8.book Page 43 Thursday, October 7, 2004 11:03 AM
Chapter 5: Installing the ST4000+

SeaTalk connections

Flat moulded plugs at each end
Flat moulded plug to round plug
Cable length
Up to 2.5 m (8 ft)
Up to 4.0 m (13 ft)
Up to 6.0 m (19.5 ft)
Note: If you need to extend the cable, you MUST use the correct cable
size.A lighter gauge cable might cause a voltage drop between the
supply and the control unit. This will reduce the power to the drive,
causing slower response to course changes and corrections.
You will not need any SeaTalk cables to install the standard ST4000+
autopilot system.
However, if you want to connect your ST4000+ control unit to other
SeaTalk equipment, you will need to purchase the necessary cables
from your Raymarine dealer.
The following illustration shows the range of available SeaTalk
cables.
Part no. Type
D284 Flat moulded plugs at each end
D285 Flat moulded plugs at each end
D286 Flat moulded plugs at each end
D287 Flat moulded plugs at each end
D288 Flat moulded plugs at each end
Part no. Type
D187 Flat moulded plug to male round plug
D188 Flat moulded plug to female round plug 0.15 m (2 in)
Copper area AWG
2
1.0 mm 18
2
1.5 mm 16
2
2.5 mm 14
Length
1 m (3 ft 3 in)
3 m (9 ft 10 in)
5 m (16 ft 5 in)
9 m (29 ft 6 in)
20 m (65 ft 6 in)
Length
0.15 m (6 in)
43
D5417-2