Table of Contents
Advertisement
The default is 30 minutes.
3. Click Submit
Configuring the library network settings
NOTE:
The RMI uses the standard internet ports—port 80 for HTTP or port 443 for HTTPS. The browser
displaying the RMI must have access through any firewalls to the library through at least one of these
ports.
Procedure
1. Navigate to the Configuration > Network screen.
2. Configure or update the Host Name and Domain Name. The RMI URL is <Host Name>.<Domain
Name>.
3. Select the internet protocol for the library.
4. Configure the settings for the selected internet protocol.
To have the library obtain an internet address from a DHCP server, select the DHCP or Stateless
method.
5. Configure the Max Link Speed for the base module library controller Ethernet ports. This setting
configures the maximum speed to which both ports will automatically negotiate. The default, 1 Gbit, is
applicable for most cases.
If the library is in a network with very high broadcast network traffic, setting a lower value can be useful
when diagnosing unexpected network failure events.
6. Click Submit.
Using the Configuration > Network Management screen
Procedure
•
Add an SNMP target
•
Edit information for an SNMP target
•
Delete an SNMP target
•
Clear all SNMPv3 options
SNMP options
The library supports both SNMP configuration and SNMP traps.
•
SNMP Enabled—When selected, computers listed in the SNMP Target IP Addresses field can
manage the library.
•
Community Name—A string used to match the SNMP management station and library. It must be set
to the same name on both the management station and the library. The default community name is
public.
62
Configuring the library network settings
Advertisement
Table of Contents
