Table of Contents
Advertisement
Installing the new drive power board
Procedure
1. Position the new drive power board onto the alignment rails.
2. Slide the drive power board into the module until seated firmly.
3. Push the latch up until it snaps into place; when the drive power board is installed correctly, the latch
will not be loose.
4. Install the module controller board in the module, taking care to align the board in the slot as it is
inserted.
5. Tighten the blue captive thumbscrews on the module controller board with your fingers to secure it to
the module.
6. Plug in any Ethernet or module interconnect cables disconnected for this procedure.
2
1
2
1
Installing the new drive power board
137
Advertisement
Table of Contents
