Table of Contents
Advertisement
•
Name—Name of the person to contact about management of the library.
•
Phone—Phone number of the contact person.
•
Email—E-mail address of the contact person.
6. If using the Data Verification feature, configure the Data Verification information.
•
Enable Data Verification and Library REST Interface—Select to allow Command View TL and
other applications using the REST interface to communicate with the library over the SSH protocol.
Enabling Data Verification and the REST interface does not enable full SSH access for the console
or other uses.
•
Data Verification and Library REST Interface User Name—The user name that the library uses
to communicate with Command View TL and all other applications using the REST Interface. This
user name is created in Command View TL and is always cvtl.
•
Data Verification and Library REST Interface Password—This password must be the same as
the Data Verification password configured for this library on the Command View TL management
station. The same password is used for all applications using the REST Interface to access this
library.
7. Click Submit.
Enabling Data Verification
Procedure
Enable Data Verification from the Data Verification information area of the Configuration > Command
View TL Configuration screen.
Preparing the library for Data Verification
The Data Verification feature provides an automated process to validate media readability and data
integrity of backup data cartridges. Data Verification is a feature of Command View that is supported by
the library and requires a license to be installed on the Command View TL management station. Data
Verification is only supported with Command View TL 3.8 and newer versions. For more information on
Data Verification, see the HPE Command View for Tape Libraries User Guide on the Command View TL
website.
The Data Verification feature uses a partition called "DVP" for the storage slots and tape drives used for
Data Verification. Command View TL moves the cartridges between the storage slots and tape drives in
the DVP partition for media verification read purposes. When Command View TL is performing move
operations, the library RMI and other library partitions can still be used. This partition is created and
configured from the Command View TL interface.
Before enabling Data Verification with Command View TL, prepare the library by freeing up resources
needed for the DVP partition and creating a private network for the tape drives and library.
Procedure
1. Use the Expert Partition Wizard to prepare the library for the data verification partition.
Enabling Data Verification
89
Advertisement
Table of Contents
