16
en | Introduction
Notice!
All connectors are pluggable screw clamp terminals.
Figure 3.5: Jumpers at the bottom side
7
8
9
3.3
Performance Characteristics
–
–
–
–
2016-11 | AMC2-16IOE |
Jumper for setting either voltage free relay output ("dry"
mode) or looped-in voltage from the AMC2 internal
power supply ("wet" mode).
DIL switch for setting the board address.
Jumper: Equalization of potential between different
systems and earth ground (shield) for the extension
interface.
Controlled by an AMC2 via RS-485
16 relay outputs
–
voltage free, power is supplied externally (dry mode)
–
powered by internal power supply (wet mode)
16 analog inputs with internal power supply
Transfer rate to the extension interface: 9,6 kBit/s
AMC2 Extensions
Bosch Sicherheitssysteme GmbH