Senco RoofPro 445XP Operating Instructions Manual page 8

tool usE
read the "Customer satisfaction
and safety reminder" (Cssr)
in the tool and fastener boxes
for safety information regarding
the Contact-Actuation and
sequential trigger modes.
under certain conditions, the
sequential trigger mode may
reduce the possibility of injury
to you or to others working with
you.
to adjust the depth the fastener
is driven:
y y
First disconnect the air supply.
y y
Using your thumb or index
finger, rotate wheel to adjust the
Depth Control workpiece contact
(safety element) to achieve
desired depth.
should a nail jam occur:
y y
Disconnect air supply.
y y
Press down on the gate latch
and lift open gate.
y y
Extract bent nail from rear of
guide body.
AltErNAtIVE
y y
Insert a rod and push the point
of the nail back up and into the
guide body bore.
y y
Extract the nail with pliers or, if
the nail is loose, turn the tool
upside-down and shake it out.
8