Senco RoofPro 445XP Operating Instructions Manual page 4

sAFEty WArNINgs
y y
Drive fasteners into work surface
only; never into materials too
hard to penetrate.
y y
Do not drive fasteners on top of
other fasteners or with the tool at
too steep of an angle; the fasteners
can ricochet and hurt someone
y y
When using tool, care should be
taken due to possibility of tool
recoil after a fastener is driven.
If workpiece contact (safety
element) is unintentionally al-
lowed to re-contact work surface
following a recoil, an unwanted
fastener will be driven. Therefore,
allow tool to recoil completely
off work surface after a fastener
is driven to avoid this condition.
Do not push workpiece contact
(safety element) on work sur-
face until a second fastener is
desired.
y y
Do not drive fasteners close to
the edge of the work surface.
The workpiece is likely to split
and the fastener could fly free or
ricochet and hit someone.
y y
Never use any part of the tool
(i.e., the cap or mainbody ) as a
hammer. The tool may activate or
become damaged and result in
an unsafe condition.
y y
Keep hands and other body
parts away from the area shown
in the circle to avoid possible
injury during operation.
y y
2
Tool may eject a fastener
when connected to air supply;
therefore,
j remove all fasteners from tool
k
before connecting air.
1
.
4