When Moving The Unit - Roland FJ-42 User Manual

3-7 When Moving the Unit...

NOTICE
When moving the unit, first carry out head washing, then secure the carriage in place. Head washing requires
three optionally available cleaning cartridges.
1 If there is material loaded, hold down the [SETUP]
key for 1 second or longer to cancel setup, then
remove the material (see "2-7 Ending Printing
Operations Remove the Material").
Press the [ ] key to make the following screen
3
appear on the display.
5 When the display shown in the figure appears, discard
the discharged ink in the drain bottle.
* Be sure to discard the discharged ink.
Attempting to replace the ink while discharged ink
remains may cause discharged ink to overflow from
the bottle.
DISCARD
When all ink cartridges have been removed, head
7
washing starts. Follow the messages on the display to
carry out the procedure.
Messages appearing during head washing
SET CL-LIQUID
[KCMcmY]
Insert a cleaning cartridge into the ink
cartridge port for the flashing color.
REMOVE CL-LIQUID
[KCMcmY]
Remove the cleaning cartridge from the ink
cartridge port for the flashing color.
K = Black C = Cyan
m = Light Magenta (G = Green)
INK CONTROL
EMPTY MODE
DRAIN TANK
M = Magenta c = Light Cyan (O = Orange)
Y = Yellow
2
Press the [MENU] key and [
following screen appear on the display.
4
Use the [ ] key to select [HEAD WASH], then press
the [ENTER] key.
INK CONTROL
HEAD WASH
6 Mount the drain bottle and press the [ENTER] key to
display the screen shown in the figure.
REMOVE CARTRIDGE
When the display shown in the figure appears, head
8
washing is finished.
Press the [POWER] key to switch off the sub power.
The POWER LED goes out
INK CONTROL
HEAD WASH
9 When the POWER
LED goes out, turn off
the main power switch.
Continued on the next page
3 Maintenance
] key to make the
MENU
INK CONTROL
[KCMcmY]
45