Boss Dr. Sample SP-303 Owner's Manual page 26

Chapter 2. Using the Effects
DSP EFFECTS
Gives the sound a "low-fidelity"
character.
15. NOISE GEN
Generates noise.
16. RADIO TUNING
Reproduces the sound being
played on the radio.
17. SLICER
Continuously cuts the sound.
Includes a flanger effect.
18. RING MOD
Creates a metallic sound quality.
19. CHROMATIC PS
Two-voice pitch shifter that
changes the pitch in semitone
steps.
20. VOICE TRANS.
Processes human vocals to pro-
duce a variety of different voices.
21. C.CANCELER
Eliminates the vocals and other
sounds located at the center.
(*2) The following choices are available for TIMING PTN when the selection is made using the CTRL 1 knob, and "17. SLICER"
is selected for MFX.
fig.r02-10
P01
P02
P03
P04
P05
P06
P07
P08
(*3) The TIMING PTN period is synchronized to the longest of the samples to which the effect is applied.
However, if a pattern is being played back, then this is synchronized to the pattern tempo.
The sync rate can be adjusted with the RATE setting as shown below.
With RATE at minimum (the CTRL 2 knob turned completely to the left):
one TIMING PTN cycle corresponds to one measure.
With RATE at maximum (the CTRL 2 knob turned completely to the right):
26
CTRL 1 (display)
Adjusts the sampling frequency.
COLOR (CoL)
Adjusts the tone of the hissing
noise.
TUNING (tun)
Adjusts the degree of noise that
occurs when tuning a radio.
TIMING PTN (P01–16)
Select a pattern to specify the timing
at which the sound will be cut. (*2)
FREQUENCY (Frq)
Adjusts the pitch of the metallic
sound.
PITCH 1 (-C–CC)
Changes Pitch 1 up or down one
octave in semitone intervals.
FORMANT (For)
Adjusts the vocal characteristics
(formant).
L-R BALANCE (bAL)
Finds the best point for deletion.
CTRL 2 (display)
Adjusts the bit count.
QUALITY (qLt)
Sets how often the scratch noise is
produced.
NOISE LEVEL (noS)
Specifies the volume of the noise.
RATE (rAt)
Adjusts the length of the
TIMING PTN. (*3)
EFFECT LEVEL (EFF)
Adjusts the volume of the effect
sound.
PITCH 2 (-C–CC)
Changes Pitch 2 up or down one
octave in semitone intervals.
EFFECT LEVEL (EFF)
Adjusts the volume level of the
effect sound.
LOW BOOST (Lo)
Boosts the bass and other low-fre-
quency sounds located at the center.
P09
P10
P11
P12
P13
P14
P15
P16
CTRL 3 (display)
Adjust the sensitivity with which
the filter will be affected.
LEVEL (LEV)
Adjust the volume level of the
hissing noise.
FREQUENCY RANGE (Frq)
Adjusts the tonal character.
FEEDBACK (Fdb)
Adjusts the degree of the flanger
effect.
DIRECT LEVEL (dir)
Adjusts the volume level of the
direct sound.
DIRECT/EFFECT BALANCE (bAL)
Adjusts the balance of the effect
sound and direct sound.
DIRECT LEVEL (dir)
Adjusts the volume level of the
direct sound.
HIGH BOOST (Hi)
Boosts the high-frequency sounds.