Deleting A Portion Of A Performance (Cut) - Roland VXpanded VS-880 Owner's Manual

Deleting a portion of a
performance (Cut)
This operation cuts playback data from the specified area.
When playback data is cut using this operation, any play-
back data following the data that was cut will move for-
ward to fill the gap. To use the analogy of a tape recorder,
this operation is like cutting an unwanted portion out of an
audio tape, and splicing the ends.
A
Start
* Do not leave sound within 0.5 seconds before or after the
area to be cut. Any sound which was within 0.5 seconds
of the cut data will not playback.
1. Press [TRACK], select "TRK Cut?", and press [YES].
The display will let you select the track and V-track from
which playback data will be cut.
CONDITION MARKER#
INPUT TRACK
2. Use [SEL (CH EDIT)] to select the track from which
data will be cut, and use the TIME/VALUE dial to select
the V-track from which data will be cut.
If you wish to execute the Track Cut operation with the
same settings for other tracks as well, press [SEL (CH
EDIT)] for the additional tracks that you wish to cut,
and use the TIME/VALUE dial to specify the V-track
that you wish to cut. If you wish to cancel the cut oper-
ation for a track, use PARAMETER [
play the setting of that track, and press [CANCEL
(NO)].
If you wish to cut data from all V-tracks of the specified
track, use the TIME/VALUE dial to select Ò Ó. If you
wish to cut data from all V-tracks of all tracks, select Ò
- Ó.
End Time
Cutting source (Track – V track)
TIME TIME
dB
0
4
1 1 2 2
24
48
AUX MASTER
][ ] to dis-
Chapter 4 Editing a recorded performance (track editing)
3. Make settings for the following items, and execute the
track cut operation.
St (starting point): Specify the starting time location
of the data which is to be cut.
End (end point): Specify the ending time location
of the data which is to be cut.
< An easy way to specify the time settings >
Times for the Start point and End point can be specified
directly without having to display the Track Cut page. In
Play condition, use the following procedure.
1. Move to the beginning of the area that you wish to
delete (Start point).
2. Hold down [TRACK] and press [LOC1/5].
3. Move to the end of the area that you wish to delete
(End point).
4. Hold down [TRACK] and press [LOC3/7].
If you now access the Track Cut page, the times that were
specified in steps 1Ð4 will be input as the time settings for
the respective points.
83