Table of Contents
Advertisement
Control
Mounting Box
With Cover
Electrical
Wiring Hole
Figure 3.6. Wall switch mounting
G. Built-in Installation
When this appliance is installed into a wall, we
recommend that the wall be an exterior wall
system.
•
See framing measurements in Figures 3.1, 3.2
and 3.4.
•
The header must not be placed below the top
of the top standoffs.
•
Non-combustible wall sheathing material is
required on the entire face and top rain shield
of this appliance. (See Figure 3.4)
Flash the perimeter of the appliance, corners and
the appliance face in a manner consistent with
regional practices as required to prevent water
penetration around the appliance.
•
This unit has an incorporated drain pan into
its base. Across the bottom front a shield is
installed to allow a moisture barrier to be taped
in a manner to shed moisture out of the unit.
See Section 3B and Figure 3.3 and 3.4 for
more information regarding wall and enclosure
construction.
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Courtyard Installation Manual • 4608-901 Rev. A • 02/18
Wall Switch
Wires
13
Hide quick links:
Advertisement
Table of Contents
