Electrolux EDW 503 Service Manual page 7

Functional Test Cycle
1. After Service mode is accessed (when L1 is blinking, L2 and L3
is on), press S1 twice before L2 and L3 is turned off
 LED L3 is blinking, L1 and L2 is turned on
2. Wait till L1 and L2 is turned off, then press S1 and close the
door.
 The cycle starts and runs the same as a normal cycle
 LED L3 blinks for the duration of the cycle
3. The cycle and be cancelled or run to its end.
Enable/disable Extra Rinse
Not available for this User Interface.
Enable/disable Pulse Wash
Not available for this User Interface.
Technical Support – A.R.
EDW503
599 79 76 - 53 REV 1.0
3.1
Chapter