Alarm Reading And Actuator Test; Functional Test Cycle; Enable/Disable Extra Rinse; Enable/Disable Pulse Wash - Electrolux EDW 503 Service Manual

User interface – Introduction
Service Mode – Function description

Alarm Reading and Actuator Test

After accessed Service mode to get the saved alarms and test
actuators.
Details of alarm code displaying are in later Alarm Code section.
LED Test / Delete Alarm Memory
To test the LEDS and erase alarm codes from memory.

Functional Test Cycle

Run a test cycle. It runs as a normal wash cycle. It can be cancelled
or run to its end.

Enable/disable Extra Rinse

An additional cold rinse phase can be added to the cycles to
improve wash performance. In factory (default) settings, this is
disabled.
Use this function to enable or disable the Extra Rinse.

Enable/disable Pulse Wash

Pulse Wash can be disabled from the cycles to improve wash
performance. In factory (default) settings, this is enabled.
Use this function to disable or enable Pulse Wash.
2
Chapter
Technical Support – A.R.
599 79 76 - 53 REV 1.0