4
CANopen Lift Option Components
◆
CANopen Lift Option SI-L3
A - Communication cable connector
B - Connector (CN5)
C - Installation hole
D - LED (RUN)
◆
CANopen-Lift Option Status LEDs
The CANopen-Lift Option has two LEDs that indicate the communication status.
■
RUN LED
LED
Color
RUN
Green
Green
Green
Green
■
ERR LED
LED
Color
ERR
–
Red
YASKAWA ELECTRIC SIEP YEUOCL1 01A CANopen-Lift Communication Option Installation Manual
(9 pin D-sub)
Figure 4.1 Option Card
Display
On
Blinking
Single flash
Flickering
Display
Off
Blinking
Single flash
Double flash
Flickering
On
4 CANopen Lift Option Components
E - LED (ERR)
F - Model number
G - Ground terminal (installation
hole)
Meaning
The device is in Operational State.
The device is in Pre-Operational State.
The device is stopped.
Automatic bit rate detection in process.
Meaning
Online.
Bus initialization failed.
A fault has occurred. Receiving CAN error frames.
Guard / Heartbeat has occurred.
Automatic bitrate detection in process.
Flickers with RUN LED alternatively.
Bus off.
9