(6) Total error rate
1. Set in the FACTORY mode.
2. Press the COUNTER button 6 times.
(Or, press the COUNTER button once in the test rec mode.)
LCD --->
tr-trnn-trtrtrtrnnntr
Note: Refer Step 3 of Troubleshooting
on pag e 25.
(71 Ageing mode
1. Set in the FACTORY mode.
2. Press the COUNTER buttonT times.
(Or, press the COUNTER button once in the total error rate.)
LCD -+
tr A GE TN GI M oD En n
3. Repeat the same operating after indicated.
4. When pressing the COUNTER button, reset in the "FACTORY MODE".
o Service mode
ReÍer Step 3 oÍ Troubleshooting on page 25. (Except, (A) Circuit Check mode.)
(A) Circuit check mode
This check mode allows checks Íor both the Main PCB circuit and mechanism operations with Mechanism PCB
separated from the mechanism. (Reelsensor and F/R switch signals are ignored.)
o Check procedure
1. Set in the FACTORY mode.
2. With the LCD shown "FACTORY 024D, press the'TEXT" button, and "SERVICE MODE" willappear on the
LCD.
LCD -*
3. Press the COUNTER button 7 times.
LCD ---->
(tr: STOP or PLAY)
Check for "R"
flnGerr.rc' rtrOoE
+
REW _>
PLAY _> F-SKtp (+2) *
pLAy (approx. Smin.)
I
L
STOP
--
SIDE A
+
PLAY (approx. s min.) <-
S|DE B <- FF (10 sec.)+g1gp
+r
n S E R V tC E n M O DE I
-2 t -