o Notice for assembling the cam gear
Trigger lever
Cam gear
spnng
Trigger lever
1 . Temporarily install the trigger lever
spring on trigger lever.
5. Latch the temporary attached trigger lever spring to the boss.
6. Install the bushing and washer.
Trigger lever
9. Pull the trigger lever one time in the direction oÍ arrow @ ,
and then rotate the main gear in the direction of arrow @ .
10. Make sure the yoke is located at the position "REV" when
the cam gear is ceased rotating.
Shaft (B
Nsserlever
Cam gear
3. Rotate the cam gear toward the position
as shown above.
4. Install the trigger lever to the shaft (B).
. Confirmation oÍ cam gear operation
Cam gear-'
7. Rotate the main gear in the direction of arrow e , and then
the cam gear associates in the direcion of arrow @.
8. Make sure the yoke is located at the posision "RVD" when
the cam gear is ceased rotating.
Cam gear
FwD ,-[3ÏóFl++ REV
1 1 . Further, pull the trigger lever one time in the direction oÍ
arrow @ , and then rotate the main gear in the direction oÍ
arrow @.
12. Make sure the yoke is located at the position "STOP" when
the cam gear is ceased rotating.
Shaft (A)
Install the cam gear to the shaft (A).
B u s h in g
Trigger lever spring
Main gear
@
e+ sroP r+ REV
M a in g e ar
Main gear
PCS 79 272
- 10 -