Table of Contents
Advertisement
(21 Guide Heights Adjustment
. Adiusting Guide (L)
Insert the check bar into tape guide (L) as shown
be l ow .
Tape
guide(L)
Check bar
Tape guide (R)
adjusting screw(L)
Check
Rear end
bar
Tape guide(L)
Lifted
Turn Q head height adjusting
-.- ?- screw (L) counterclockwise.
Vr
I+
I I
'
\Turn
o head height adjusting
screw(L) cloclcwise.
Turn @ head height adjusting screw (L)
bar off the base, then slowly turn the
parallel and rests on the base.
. Adiusting Guide (R)
Insert the check bar into tape
guide (R) as shown below.
c ou nter cl o ckw i se to l if t t he re a r end of th e c hec k
screw clockwise to lower the Íear end until it is
Tape
uide(L)
Check bar
Tape guide (R)
l-{eíad @ Head height
adjusting screw(R)
Turn @ head height
TaPe guide (R)
aàiusÍng sóie'"(Ëi ---
\
Rear end
Gheck bar
\ -
-í
Lifted
clockwise.
- -r*t
Note:
Turn @ head height adjusting screw (R) clockwise to lift
off the base, then slowly turn the screw counterclockwise
parallel and rests on the base.
Be careful not to lift
the check bar end more
than 1.Smrn, as the screw
may loosen completely
and pop out.
t he re ar e nd of t he ch eck bar
to lower the Íear end until it is
Note:The head arm has a slight amount of play. Make sure that the rear end of the
check bar completely rests on the base after the screwdriver is removed.
Base
PCS 79 276
- 14 -
Advertisement
Table of Contents
