Table of Contents
Advertisement
o Removal of the motor and belt
1 . Follow the procedures in Ref. No. 1 - 10 in the Disassembly
instructions.
(ReÍer to pages 3 - 6.)
2. Remove the 2 screws( O , @ ).(ReÍer to Fig. 1 .)
3. Remove the 2 screws( O, () ) and the Íixing ptate,(ReÍer
to Fig. 2.)
4. Remove the motor in the direction oí arrow.(ReÍer to Fig. 2.)
5. Remove the belt from the motor.(ReÍer to Fig. 3.)
Fig. 1
o BeÍor installing the belt to the motor, insert the
unmagnetized sheet to the clearance between
chassis and lower portion oÍ motor, and then
push the upper portion of motor in the direction
oÍ arrow.
Put the belt into the clearance between upper
portion of motor and coil P.C.B.
(Refer to Fig. 4 and 5.)
Fig. 2
Motor
Belt
Unmagnetized
1 sheet or similar
;material
Upper portion
oÍ motor
Coil P. C. B.
Lower portion
of motor
Fig. a
4. Remove the 1 screw( O )
5. Remove the washer.
6. Remove the cam gear in
Fig. 3
Stretched
Chassis
( Thickness:
0.2-0.3 mm )
o Removal of the cam gear and solenoid
1 . Follow the procedures in ReÍ. No. 1 - 10 in the Disassembly
instructions. (ReÍer to pages 3 - 6.)
2 . P u l l o u t th e bus h ing .
3. Remove the trigger lever.
Note: Avoid missing the trigger lever spring when removing
the trigger lever.
and the solenoid.
the direction of arrow.
Fig. 5
Trigger lever
Trigger lever
spnn9
Solenoid
Washer
S o l eno i d
PCS 79 270
-8 -
Advertisement
Table of Contents
