M.2 Solid-State Drive - HP EliteBook 840r G4 Maintenance And Service Manual

M.2 solid-state drive

Description
1 TB, PCIe Gen3x4, NVMe, TLC
512 GB, PCIe, Gen3x4, TLC
512 GB, PCIe, NVMe, self-encrypting drive (SED), Opal 2, TLC
512 GB, SATA-3, FIPS 140–2, TLC
360 GB, PCIe, Gen3x4, NVMe, TLC
256 GB, PCIe, Gen3x4, NVMe, TLC
256 GB, SATA-3, NVMe, self-encrypting drive (SED), Opal 2, TLC
256 GB, PCIe, NVMe
128 GB, SATA-3, TLC
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the M.2 solid-state drive.
36 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Bottom cover on page
Battery on page
M.2 solid-state drives are designed with notches to prevent incorrect insertion.
30).
33).
Spare part number
L17991-001
L17996-001
L17995-001
L17994-001
L17997-001
L17992-001
L17989-001
L17993-001
L17990-001