Table of Contents
Advertisement
CARE & MAINTENANCE
CLEANING
REPLACING OVEN
IMPORTANT: ALWAYS UNPLUG OV-
POWER CORD - Be sure oven is un-
LIGHT BULB
EN AND BE SURE OVEN IS COOL BE-
plugged. Wipe cord with a damp sudsy
USER REPLACEABLE BULB:
FORE CLEANING.
cloth, rinse and dry thoroughly before
Disconnectpowertotheovenbeforere-
plugging cord back into outlet,
placing oven light bulb. Bulb is located
To maintain the appearance of your ov-
on the upper right oven wall.
en, never use abrasive cleaning agents
INTERIOR SURFACES
(such as cleansing powders, scouring
pads or steel wool pads.) Also, never
Be sure oven interior is cool before
To replace bulb:
use commercial oven cleaners on any
cleaning. Never use commercial oven
1. When oven is cool, loosen hex nut
part of your microwave oven.
cleaner on any part of your microwave
with a 1/4" nut driver or remove
oven.
screw on lamp access cover with a
OVEN WALLS - Use a mild liquid dish-
straight-blade screwdriver.
washing detergent and water; rinse and
dry. To loosen dried-on soil: Place a
2. Carefully remove cover plate.
cup of water in oven. Microwave on
HIGH for 3 minutes. Leave hot water in
the oven and allow the steam to soften
3. Remove bulb. If bulb should break,
the soil. Then, wash with hot sudsy
use a pot holder to protect hands
water; rinse and dry.
from possible harm and very care-
OUTSIDE
SURFACES
fu,y remove bulb. If bulb breaks at
COVER- Clean the outside of the oven
To keep oven clean and sweet-smell-
base, have a servicer remove bulb.
with a glass-cleaning agent, a liquid
ing: Open oven door for a few minutes
cleaner or dishwashing detergent and
after cooking. Allow moisture to evapo-
rate or wipe interior with a dry cloth. Oc-
(_ _
water. Use a damp cloth or sponge,
casionally wipe walls with a solution of
Rinse and dry.
baking soda and water to keep interior
fresh.
PLASTIC - Use a liquid or glass-clean-
ing agent and a sponge or cloth. To pre-
PLASTIC STIRRER COVER - Never
__.
t _
,_.__j
vent scratching the plastic surface, do
remove the stirrer cover. If this part re-
not use paper toweling,
quires service, contact a qualified ser-
vicer.
CHROME - Clean chrome trim with liq-
uid or glass-cleaning agent and a cloth
OVEN SHELF - Wash oven shelf with
or sponge. Buff dry with a soft cloth to
hot sudsy water, rinse and dry.
prevent scratching the surface.
4. Replace bulb with a 25-watt or T8
If a stain should still remain, remove it
bayonet base bulb only. Replace
DOOR and CONTROL PANEL- Clean
with a paste of two parts coffee-pot
cover plate. WARNING: After re-
with a damp cloth or sponge. Use dish
cleanser and three parts water. Apply
placing oven light bulb, do not at
washing detergent and water or aliquid
paste to stain, let stand one or two
tempt to operate oven without lamp
or glass-cleaning agent to remove soil.
hours; then wipe with a clean damp
cover plate installed.
Rinse with a damp cloth and dry with a
cloth, rinse and dry.
soft cloth to prevent scratching the plas-
tic outer door panel. Some paper towels
5. Reconnect power to oven.
can scratch the plastic door panel,
therefore, use a soft cloth to dry the
door.
-32-
Advertisement
Table of Contents
