Table of Contents
Advertisement
MAINTENANCE
ELECTRICAL
OVEN BURNER
HOW TO REMOVE OVEN
CONNECTION
The size and appearance of a properly
FOR
CLEANING
AND
Appliances which require electrical
adjusted even burner flame should be
SERVICING
power are equipped with a three-prong
as shown:
When necessary, follow these proce-
grounding plug which must be plugged
dures to remove appliance for cleaning
directly into a properly grounded three-
_
or servicing:
hole 120 volt electrical outlet.
1. Shut-off gas supply to appliance,
i
--
•
_ :
:
Oonein centeris smaller
2. Disconnect electrical supply to appli-
_
(.__
Eq
ance.
_
_ •
3. Disconnect gas supply tubing to ap-
,,
:
pliance.
_
_" , _
Cone approx, 1/2-inch
4. Remove screws that secure appli-
ance to cabinet. Remove appliance
from cabinet.
Always disconnect power to appfi-
ance before servicing.
The oven temperature is maintained by
5. Reverse procedure to reinstall. If gas
cycling the burner on and off. After the
line has been disconnected, check
oven temperature has been set, there
for gasleaksafterreconnection. (See
If an ungrounded, two-hole or other
will be about a 45 second delay before
Installation Instructions tot gas leak
type electrical outlet is encountered, IT
the burner ignites. This is normal, and
test method.)
ISTHE PERSONAL RESPONSIBILITY
no gas escapes during this delay.
OF THE APPLIANCE OWNER TO
NOTE: A trained serviceman should
HAVE
RECEPTACLE
REPLACED
During the clean cycle, and some ex-
makethegasinstallation,disconnection
WITH A PROPERLY GROUNDED
tended oven cooking operations, you
and re-connection of gas supply to ap-
THREE HOLE ELECTRICAL OUTLET.
may hear a "popping" sound when the
pliance.
The three-prong grounding plug is pro-
burner cycles off. This is a normal oper-
vided for protectionagainst shock haz-
ating sound of the burner.
ards. DO NOT CUT OR REMOVE THE
OVEN LIGHT
THIRD GROUNDING PRONG FROM
To turn on oven light, press "oven"
THE POWER CORD PLUG.
rocker switch, located on control panel.
To replace oven light: Before replac-
ing lightbulb, DISCONNECT POWER
TO OVEN. Be sure bulb is cool.Do not
toucha hotbulbwitha dampclothas the
bulb may break. Use a dry potholder
and carefully unscrew bulb cover and
bulb.
Replace with a 40 watt appliance bulb.
Reconnect power to oven and reset
clock.
-13-
Advertisement
Table of Contents
