Table of Contents
Advertisement
TROUBLESHOOTING CHART FOR WALL OVEN
BEFORE
CALLING
A SERVICE
TECHNICIAN,
CHECK THE FOLLOWING:
1. Burner flame uneven,
a. clogged burner port(s),
a. clean ports with straight pin. Be
sure ignitors are not sparking.
2. Burner fails to light,
a. power supply not connected,
a. connect power, check circuit
breaker or fuse box. Oven will not
operate during a power failure.
b. controller incorrectly set.
b. see page 6.
3. Oven temperature inaccurate,
a. oven not preheated,
a. preheat oven 10 minutes.
• food takes too long or cooks to
b. incorrect rack position,
b. see page 10.
fast.
c. incorrect use of foil.
c. see page 10.
• pale browning,
d. oven
bottom
incorrectly re-
d. replace oven bottom correctly.
• food over--doneon outside and
p/aced.
under-done
in center,
e. oven thermostat sensing device
e. reinsert sensing device securely
• over browning,
out of holding clip(s),
into clip(s).
4. Clock and/or light do not work.
a. power supp/y not connected,
a. connect power supp/y, check cir-
cuit breaker or fuse box.
b. burned out light bulb.
b. replace light bulb.
c. malfunctioning switch,
c. call serviceman to check.
d. malfunctioning clockorloosewir-
d. call serviceman to check.
ing.
5. Popping sound
heard when
This is a normal sound that occurs with some types of gas when a hot burner is
burner extinguishes,
turned off. The popping sound is not a safety hazard and will not damage the appli-
ance.
F plus a number appears in the dis-
This is called a FAULT CODE. If a fault code appears in the display, press the
play and a continuous beep sounds.
STOPCLEAR pad. If the fault code reappears, disconnect power to the unit and
(Example: F 1)
call the servicer.
EXPLANATION OF FAULT CODES
Your appliance is equippedwith an electronic control featur-
DURING NORMAL OVEN COOKING
ing built-in, self-diagnostic software. This software continu-
If a fault code appears in the display and continuous beeps
ousfy monitors the control to insure safe and proper opera-
sound, press the STOP/CLEAR pad. Then, reprogram the
tion. Ifthe software should detect a questionable situation,a
cooking operation.
FAULT CODE (F plus a number) will appear in the display
and continuous beeps will sound.
If the fault code reappears in the display, call a servicer. Do
not use the oven until the control has been serviced. The
surface unit can be used.
I
Io)
i
L
"
O .INGA EL-C ANCYOLE
If the oven is heavily soiled, excessive smoke and f_aring
may result in a fault code. If this occurs, press the STOP/
CLEAR pad and allow the oven to cool for an hour. Then,
reprogram the oven for the clean cycle.
A fault code indicates that there may befunctionalerror. As a
safety precaution, the control will automatically cancel the
if the fault code reappears in the display, call a servicer. Do
program. Follow the procedures described to check the ap-
not use the oven until the control has been serviced. The
pliance,
surface unit can be used.
-15-
Advertisement
Table of Contents
