Roberts Gorden CoRayVac CRV-B-12 Installation & Operation Manual page 25

Step 7.4.3 Reflector, U-Clip and Reflector Support Installation
The pictorial drawings of the heater construction in
Section 7 are schematic only and provide a general
guideline of where hangers, reflector supports and
U-clips are to be installed.
To ensure proper expansion and contraction
movement of the reflectors, a combination of U-clips
and reflector supports are used. The positioning of
Description
Reflector Support Package
Wire Form
Reflector Support Strap
Screw #8 x 3/4
U-Clip Package
Reflector End Cap
Part Number
03050010
91908004
03050000
94320812
91107720
027508XX
reflector supports and U-clips depend on the
individual installation. Use either pop rivets or sheet
metal screws instead of u-clips when installing end
caps and joint pieces in areas where impact and high
wind may be a factor. The following rules must be
observed.
SECTION 7: H I
EATER NSTALLATION
19