M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P371
Facing t-post MR illegal
Details
Mirror image for facing tool posts was commanded to an axis in external mirror image or parameter mirror
image.
The commanded mirror image for facing tool posts enables the mirror image for a rotary axis.
Remedy
Correct the program.
Correct the parameter settings.
P380
No spec: Corner R/C
Details
The corner R/C was issued though it is out of specifications.
Remedy
Check the specifications.
Delete the corner chamfering/corner rounding command in the program.
P381
No spec: Arc R/C
Details
Corner chamfering II or corner rounding II was commanded in the arc interpolation block though it is out of
specifications.
Remedy
Check the specifications.
P382
No corner movement
Details
The block next to corner chamfering/ corner rounding is not a travel command.
Remedy
Replace the block succeeding the corner chamfering/ corner rounding command by G01 command.
P383
Corner movement short
Details
The travel distance in the corner chamfering/corner rounding command was shorter than the value in the corner
chamfering/corner rounding command.
Remedy
Set the smaller value for the corner chamfering/corner rounding than the travel distance.
P384
Corner next movement short
Details
The travel distance in the following block in the corner chamfering/corner rounding command was shorter than
the value in the corner chamfering/corner rounding command.
Remedy
Set the smaller value for the corner chamfering/corner rounding than the travel distance in the following
block.
P385
Corner during G00/G33
Details
A block with corner chamfering/corner rounding was given during G00 or G33 modal.
Remedy
Correct the program.
P390
No spec: Geometric
Details
A geometric command was issued though it is out of specifications.
Remedy
Check the specifications.
143
IB-1501279-H