Monitoring The Position Average Value 'P.\\Pavg; O3.Fact2 - Factor 2; O4.Fact3 Factor 3 0.1 - Siemens SIPART PS2 Operating Instructions Manual

O3.FACT2 - Factor 2

Adjustment range:
Purpose:
Factory setting:
O4.FACT3 - Factor 3
Adjustment range:
Purpose:
Factory setting:
See also
Display of diagnostics values (Page 198)
9.4.3.12

Monitoring the position average value 'P.\\PAVG'

P. PAVG - Monitoring the position average value
Requirement:
Possible settings:
Purpose:
Factory setting:
SIPART PS2 with and without HART
Operating Instructions, 05/2017, A5E00074631-AC
0.1 ... 40.0
Use this sub-parameter to set the factor for formation of threshold 2.
Set the factor in a range from '0.1' to '40.0'. The threshold is the
product of 'O1.LIMIT' and 'O3.FACT2'.
The threshold 2 message is displayed when threshold 2 is excee‐
ded. This message is only output if threshold 3 is not exceeded at
the same time. The process to activate and display this message is
described in the 'XDIAG' parameter.
2.0
0.1 ... 40.0
Use this sub-parameter to set the factor for formation of threshold 3.
Set the factor in a range from '0.1' to '40.0'. The threshold is the
product of 'O1.LIMIT' and 'O4.FACT3'.
The threshold 3 message is displayed when threshold 3 is excee‐
ded. The process to activate and display this message is described
in the 'XDIAG' parameter.
5.0
The '52.XDIAG' Activating for extended diagnostics (Page 166) pa‐
rameter is set to 'On1', 'On2' or 'On3'.
● OFF
● On
Use this parameter to activate the test to calculate and monitor the
average value of position. During the test, the average values of
position and reference are always compared at the end of a time
interval.
The current value is displayed in Diagnostic value '20.PAVG - Aver‐
age value of position' (Page 206). The positioner triggers a message
if the current average value of position undershoots one of the three
thresholds.
OFF
Parameter assignment
9.4 Description of parameters
189