ZyXEL Communications P-320W v3 User Manual page 62

Chapter 4 Wireless LAN
Table 23 Network > Wireless LAN > General
LABEL
Security
Mode
Apply
Reset
See the rest of this chapter for information on the other labels in this screen.
4.4.1 No Security
Select No Security to allow wireless stations to communicate with the access
points without any data encryption.
Note: If you do not enable any wireless security on your P-320W v3, your network is
accessible to any wireless networking device that is within range.
Figure 33 Network > Wireless LAN > General: No Security
The following table describes the labels in this screen.
Table 24 Wireless No Security
LABEL
Security
Mode
Apply
Reset
62
DESCRIPTION
Select Static-WEP, WPA-PSK, WPA, 802.1x + Dynamic WEP or
WPA-PSK/WPA2-PSK (Mixed) to add security on this wireless
network. The wireless clients which want to associate to this network
must have same wireless security settings as this device. After you select
to use a security, additional options appears in this screen. See 4.4.2,
4.4.3, 4.4.4 sections. Or you can select No Security to allow any client to
associate this network without authentication.
Note: If you enable the WPS function, only No Security and WPA-
PSK are available in this option.
Click Apply to save your changes back to the P-320W v3.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Choose No Security from the drop-down list box.
Click Apply to save your changes back to the P-320W v3.
Click Reset to reload the previous configuration for this screen.
P-320W v3 User's Guide