Ricoh 3030 Operating Instructions Manual page 45

Note
❒ If you try to switch to a pro-
tocol from one for which
[Path], [User Name] or [Pass-
word] is specified, a message
asking you to confirm the
protocol change appears.
C Press [Manual Input] on the right
side of the server name field.
The soft keyboard appears.
D Enter a server name.
Note
❒ For details about the maxi-
mum number of characters
that can be entered, see p.123
"Scan to Folder".
❒ An IP address also can be en-
tered.
E Press [OK].
F Press [Manual Input] on the right
side of the path field.
The soft keyboard appears.
G Enter the path for the folder.
Note
❒ For details about the maxi-
mum number of characters
that can be entered, see p.123
"Scan to Folder".
❒ The following is an example
of a path where the folder
name is "user" and the sub-
folder name is "lib": user\lib
H Press [OK].
Sending Scan Files by Scan to Folder
I Enter the user name according
to the setting at the destina-
tion.
Press [Manual Input] to the right
of the user name field to display
the soft keyboard.
Reference
For details about the maxi-
mum number of characters
that can be entered, see p.123
"Scan to Folder".
J Enter the password according
to the setting at the destina-
tion.
Press [Manual Input] for [Pass-
word] to display the soft key-
board.
K To change the port number
which is set in [System Settings],
press [Change] on the right side
of the port number field. Enter
a p o r t n u m b e r u s i n g t h e
number keys, and then press
the {#}key.
L Press [Connection Test].
A connection test is performed
to check whether the specified
shared folder exists.
Note
❒ The connection test may take
time.
❒ You may not be able to press
[Connection Test] right after
pressing [Cancel] during a
connection test.
3
37