Honeywell ADEMCO 5804-2 Installation Instructions

INSTALLATION INSTRUCTIONS
GENERAL INFORMATION
The 5804-2 is a compact, 2-button
portable wireless transmitter intended
for use only with wireless alarm
systems that support 5800 series
receivers. Each button
transmitter may be programmed for
any zone response, but is typically used
for arming and disarming.
The 5804-2 is powered
replaceable lithium batteries designed to
provide up to 4 years of life.
battery installation, see B a t t e r y
Access .
PROGRAMMING
Each 5804-2 is assigned a unique serial
number during manufacture.
button on the unit also has a distinct
"loop" number (refer to Figure 1) that
you must program into the control
panel during installation. Assign each
button to an individual zone and
designate the Input Type as "BR"
(Button Type RF).
When prompted for the serial number,
either press and release the button you
are programming twice, or manually
enter it through the keypad.
For complete details on how to program
the 5804-2 transmitter's serial number
at the control panel, see the control
unit's installation instructions.
Note: Buttons on this transmitter must
be pressed for at least 1/2 second to
activate the transmitter. This feature
minimizes the possibility of accidental
transmissions.
WIRELESS KEY TRANSMITTER
on the
by two
For
Figure 1: 5804-2 showing button
Each
SPECIFICATIONS
Unit Dimensions:
57mm x 38mm x 12.7mm
+ POS. end
must face down
N7674-3 5/99 Rev. B
ADEMCO 5804-2
LOOP 3
LOOP 2
designations
+ POS. end
must face down