Oven Racks And Rack Supports; Oven Door - Jenn-Air S105 Use And Care Manual

Oven Racks and Rack Supports
Oven Racks: To remove, pull forward to the "stop" position; lift up on the front of the
rack and pull out.
Oven Rack Supports: To remove, lift support holders from slots at the front of the
oven then move supports away from oven wail. Pull forward to remove from oven. To
replace, reverse procedure. Be sure front supports are correctly in place so that racks
will be level.
Oven Door
The oven door can be removed for ease
in changing the light bulb or for ease in
cleaning the area outside the door
gasket that is normally not cleaned dur-
ing the self-cleaning process. (See page
34.) Do not immerse the oven door in
water. Do not dampen the door gasket.
To remove oven doors Open door to the broil stop position. Grasp door on each
side and lift straight up and off the hinges. Oven door is heavy; lift carefully.
To replace oven door: Position slots in bottom of door over the hinges. Hinges
shou[d be in the broil stop position, If the hinges have snapped back against the frame,
carefully pull them out with your hand. Lower door slowly and evenly over both hinges at
the same time.
CAUTION: Be careful not to get hand or fingers caught between the door hinge and
oven front.
39